Video for the PO-32 to MicroBrute sync project

I made a short video showing how the sync circuit of the previous post works:

I've not made many of such videos yet, and I clearly need some work on figuring out how to set this up better, but hopefully it shows the most important aspects.

The details are as follows:

• 3.5mm stereo male to two 3.5mm mono male splitter cable, one goes to the circuit as shown, the other to a MouKey MAMX3 mixer.
• The PO-32 is in SY1 mode, which can be done using the * button combined with the BPM button.
• The Arturia MicroBrute is in "gate" mode, this can be configured with the program on a PC hooked up through the USB port.
• The Arturia MicroBrute has a recorded sequencer pattern, ideally with a length matching the drum pattern (16 beats, usually).
• The first note of the pattern will be the note played on the keyboard.

In the schematic the 100k Ohm resister IS the Arturia MicroBrute. There is no need to actually put the resistor in the circuit. I added it to aid the simulation.